FLUX Pre Filter for BeamAir
£21.94
£18.28
SKU
BEAMAIR-PRE
For FLUX laser cutter machines click here.
Flux Pre Filter Replacement for Beam Air
These are the replacement Pre-filters for your Beam Air. There are 4 per pack and they need to be replaced every 10-30 hours.
Don't forget to replace all filters in time:
- Pre-Filter (10-30 hours)
- Medium efficiency filter (50-150 hours)
- H13 HEPA filter (100-200 hours)
- Charcoal filter (300-600 hours)
Remove the filters:
Just open the top cover of the filter and remove the box from the inside. Then take out the Pre-filter and pull on the lids on each side of the Medium efficiency filter, put this aside and repeat the same steps with the charcoal filter. The box that's left is the H13 HEPA filter. Replace what is necessary.
Reassemble:
Reinsert the filters in this order: From left to right
- Bottom
- H13 HEPA filter
- Charcoal filter
- Medium efficiency filter
- Pre-filter
- Lid
Close the lid and you are ready to go back to creating more awesome creations!
![](https://www.daemon3dprint.com/media/.renditions/wysiwyg/air_filter_order_flipped.png)
Write Your Own Review
What's in the Box
- 1 x FLUX Pre Filter for BeamAir